If your property is fitted with a burglar alarm Unipol will give you a code to operate it at the beginning of your tenancy. You must not change the code on the alarm, write it down, or tell it to anyone.

If there is a fault on the alarm or you are unsure how to use it, call Unipol.

Basic Operation

To operate the alarm, enter your code to switch the alarm on, and enter the code to switch the alarm off.

To set the alarm (turn it on):

The day indicator should be showing. Enter your code number. Check that the system is clear (none of the zone indicators are showing). If clear, the sounder will produce a bleep tone and you may leave the property. The system will set at the end of the exit time and the bleep tone will stop.

To unset the system (turn it off):

Enter your code, if the system is clear (no alarm has been activated) the system will return to day mode. If the system has been activated, entering the code will turn off the alarm. Press RESET to clear the display and return to day mode.

To omit a zone:

Starting from the day mode, enter your code and the exit tone will start. Press the OMIT button and the exit tone changes to an omit tone. Now enter the zones you wish to omit. Omitted zones will now light up. If you make a mistake, press 0 to cancel and then enter the zones required to be omitted.

When the selection is correct, press SET. The system will now return to exit mode and the exit tone will continue.